Adapters/End Caps/Other

Add a moderator to this adapter to make the Condor SS super quiet. Also works with TalonP and Talon SS. 1/2x20 UNF thread. Features:  Compatible with .177 to .25 Made by CNC for accuracy Material is 6061 T6 Aluminum Black...

Add a moderator to this adapter to make the Talon SS and TalonP super quiet. Also works with the Condor SS. Features:  Compatible with .177 to .25 Made by CNC for accuracy Material is 6061 T6 Aluminum Black anodize Diamond pattern...

Finally an answer to the Airforce Texan line up. Made of steel M18x1 threads compatible with .357 Ronin or Emperor with M18x1 endcap Comes with black anodized Aluminum thread protector Adapters are tight fit and has two set screws (M4) to help...

Have a 350mm barrel and want to be able to screw on a 1/2 x 20 moderator? Then this is the kit you want. Without the moderator, the gun is shorter than the factory setup. This adapter attaches to the barrel by 3 set screws. Screw uses 1/16 allen key...

 *NOT NEEDED FOR GEN. 2 CROWN SHROUDS. Replaces the FX Crown factory shroud end-cap. Occasionally heat is required to remove end cap from shroud. Made by CNC for accuracy Material is 6061 T6 Aluminum Matte Black anodize Knurled thread...

This adapter is for Impacts and .177/ .22 Wildcats that have the M20x1 male threaded end. It will screw onto your factory shroud and allow you to screw on an LDC with a 1/2 x 20 UNF Female threads. Features: Made by CNC for accuracy Material is...

These adapters are for Wildcat shrouds that extend past the air tube and has female threads once you remove the front shroud cap. It is also compatible with FX Royale 400. This adapter is Male to Male, one side is M20x1 that goes into the shroud and the...

*NOT COMPATIBLE WITH MOST MKII & ALL MKIII WILDCATS. This shroud extension is for shrouds that sits behind the lower air tube. This adapter threads on a FX(20mm) Shroud and goes to 1/2"x20 UNF. This extension will replace the OEM extension but will...

Interchangeable rear endcaps for the latest model of Ronin and Emperor. Works with models with the grooves in the front cap.  

Interchangeable rear endcaps for the latest model of Sumo, Tatsu and Shogun. *Works with models with the grooves in the front cap.

Get additional end caps to use with your DonnyFL KOI and Tanto!  

This is a 1/2"x20 UNF shroud protector for the FX Factory Shroud. The newer FX Impact MKII, FX Crown and FX Wildcat MKII have the 1/2" x 20 UNF thread.

Replaces the factory end cap for the QE shroud. 1/2" unf threaded.  Features:  CNC Matte black Anodized Includes knurled thread protector Compatible up to .30

These end caps are for Huggett Moderators. Please select the correct moderator model and thread type you need on the end cap.

This adapter will screw into the Mutant OEM shroud. Has 1/2 x 20 UNF male threads that allows you to screw on any 1/2 x 20 female threaded LDCs. Features: Made by CNC for accuracy Material is 6061 T6 Aluminum Black anodize Cap with diamond pattern...