Ronin is big and bold, but it looks great even on compact bullpups. “Maybe a little overkill for the .177 and .22 but it looks so damn awesome!” – Donny
-
Available in .25 and .30 calibers
- 2 x 6.5 inches
-
1/2 x 20 UNF, M20, 1/2 x 20) & Vulcan thread by request.
-
Mono-core design to increase accuracy and limit the chances of pellet clipping
-
No moving parts or epoxy that may become lose after 1000’s of rounds
-
Precision CNC’d by professional machinist
-
Sand blasted and anodized for maximum durability
-
Take apart in less than 10 seconds by unscrewing the rear end cap and pushing back the mono-core. No silly hex key or torch needed when you want to perform maintenance inside the unit.
-
Customizable, you can further dampen the sound by wrapping the interior tube with different sound absorbing materials.
-
Comes pre-wrapped in felt
-
Machined grooves on the outside for easy handling.
*Note: If you see white lines on the inside of the front cap, that’s ok. Those were caused by the prongs holding the pieces while anodizing. They are not pellet clippings.
*DISCLAIMER: These DonnyFL products are INTENDED for the use on airguns only.  It is a violation of Federal law to use this product in a manner inconsistent for which it was intended for. It is your Responsibility to know the laws in your state, county and city and to fully comply with them. *Shipping within the United States only*
